http://www.dakkadakka.com/dakkaforum/posts/list/8.page JForum - http://www.jforum.net
I've used the GF9 drill for larger metal models, but this here is tiny. So I need a finer drill.

Suggestions?]]> http://www.dakkadakka.com/dakkaforum/posts/preList/495879/5099354.page http://www.dakkadakka.com/dakkaforum/posts/preList/495879/5099354.page GMT
Go over to your local Train Hobby or Modelling Hobby shop and ask if they have brass rods. Find the diameter that you're happy with.

See if they also have drill bits of almost larger size than the brass rods; the rods should have the diameter labelled on the package.

For my models, I use 0.031in / 0.81mm rods from a company called K S Engineering. Stock Number 1602.
The Drill Bits from the store are super-cheap (about $0.60 each).]]> http://www.dakkadakka.com/dakkaforum/posts/preList/495879/5099419.page http://www.dakkadakka.com/dakkaforum/posts/preList/495879/5099419.page GMT bits is the issue, I can't help with Scandinavian suppliers, sadly, but they are available from specialty suppliers, whether actual modelling/hobby shops or more general outfits, like MicroMark.

Can't recall where, exactly, but I picked up a cheap set of diamond coated (they're slower going through soft materials, since they're cheap - they grind their way down more than cut - but they can drill nearly anything) micro drill bits (sizes #61-80) for a couple of dollars.]]> http://www.dakkadakka.com/dakkaforum/posts/preList/495879/5099829.page http://www.dakkadakka.com/dakkaforum/posts/preList/495879/5099829.page GMT