http://www.dakkadakka.com/dakkaforum/posts/list/8.page JForum - http://www.jforum.net
I'm planning on using 'Super fine milliput' and some 1.5mm plasticard to convert some of my miniatures. The question is what tools will i need to get this done, i have a set of files and a pair of clippers and a drill set i can use. Also if you can point me towards any tutorials on cutting plasticard in circles i would be thankful.

Cheers,

Almighty ]]> http://www.dakkadakka.com/dakkaforum/posts/preList/498643/5143606.page http://www.dakkadakka.com/dakkaforum/posts/preList/498643/5143606.page GMT
http://www.amazon.co.uk/Olfa-Compass-Cutter-cutting-circles/dp/B000BK7NWC/ref=sr_1_7?ie=UTF8&qid=1357490366&sr=8-7

There are three tricks to using it.

1. Don't press too hard. Apply light pressure and make many sweeps to make light cuts.
2. You can hold the cutter still and turn the card in a circle.
3. Once the central pin has pricked through to the other side, reverse the plasticard and cut through from the other side.

With regards to the putty, although I am a fan of Milliput, there are some applications in which you will get better results using Green stuff or Brown stuff.]]> http://www.dakkadakka.com/dakkaforum/posts/preList/498643/5143859.page http://www.dakkadakka.com/dakkaforum/posts/preList/498643/5143859.page GMT
I generally cut plasticard with a knife, using the "score and snap" method. It still works on curves, but the edge is never as clean as it is on a straight cut, where a few quick scrapes with the knife is enough to get things nice and square. The shears leave an edge nearly as rough as scoring and snapping, but are much faster and easier to control for comparable results.

For the sculpting and gap-filling portion, you'll need some sculpting tools. There are reasonably cheap commercial sets of various size available in stainless steel, as well as the more expensive silicone-tipped "clay shapers" favored by GS users for their non-stick heads and slight give (aids in smoothing). If budget or expediency is a concern, much can be done with simple DIY tools - cocktail sticks/toothpicks/skewers, carved popsicle/craft sticks, pins, hammered/filed nails, bits of wire, etc.

A knife, files (a few shapes will do - in a set of 12, I'll likely use three or so for 90% of my work. Also, I find good, single-cut steel leaves a better finish than diamond-grit), and pin vice/drill bits are all you really need to get started. Clippers can save you some time, but I think a razor or jeweler's saw is even more important, for those thicker cuts, especially in metal (too hard) and resin (too brittle), that a knife or clippers can't handle.

Beyond that, just get stuck in. As you go, you'll see where you start getting bogged down or hit walls, then improvise or search out tools for that task. Over time, you'll find yourself already equipped for more and more of the things you want to do.]]> http://www.dakkadakka.com/dakkaforum/posts/preList/498643/5144109.page http://www.dakkadakka.com/dakkaforum/posts/preList/498643/5144109.page GMT