Comments:
davethepak
2016-02-16 04:42:54
This is a WIP shot of a forgeworld tau orca I built a while ago.
This was my own personal model, and thus when done will match the paint scheme of the remainder of the tau army.
In this view, the support struts for the engines are being attached - using two part epoxy.
I did one side at a time, and set the model down on the struts for a better bond, and so any excess glue would not leak out. Just after this shot was taken, additional supporting objects were placed up against the model, to help prevent it falling over in case my work surface was bumped. |
|
You must be logged in to post comments.
|
| Image Details: |
| Resolution: | 3264x2448 |
| Uploaded: | 2014-07-08 05:06:47 |
|
|
