So, i just got the
GK Terminators, and i noticed that they have a wide choiche of weapons, so i decided to figure out a way to exchange them every time i want. This conversion also allows you to acutally make them fully dynamic, so that they can rotate the torso, arms, hands and head: allowing you to change their poses as many times as you want.
For this conversion you just need the followings:
- Miniatures (what else are you going to convert without them?)
- Hobby drill (1mm recommanded)
- 1mm tick copper wire or Paperclips
- Superglue and Green Stuff/Adhesive putty (Not necessary, but very handy)
1) Drill the pelvis as shown in the picture, then put a drop of superglue on the pin and place it into the hole; cut it so it's 1cm long (you will adjust it later, when placing the head)
2) Drill the torso section: an hole for each arm (make them as deeper as possible), and another hole that goes from the neck to the pelvis; place the torso into the leg pin
3) Drill the arms like shown in the picture, supergle another pin into the shoulders, just like you did for the phase 1; also drill a deep hole into the wrists and the head
4) Now drill all the weapons hands, and superglue the pins into them; then apply a SMALL amount of fresh Green Stuff or Adhesive Putty into the holes and pins, in order to increase the drag and make them more stable.
5) Assemble the Terminators with the weapons of choiche, and have fun testing unlimited poses