Current pictures in last post
My last thread,
The Power Klaw, was a pretty big build so I figured I'd show a simpler build this time
This is my Widowmaker Mark 3 Personal Plasma Caster
I will admit it is my own take on the and I changed the spark chamber. So it might be an older variant or a blackmarket criminal weapon.
The first part of the build is the base I used a small piece of scrap 2 by 4, and a section of scrap 1 by 1 cut at a comfortable angle. I screwed down the handle before wrapping it in black duct tape. I used a piece of PVA foam bolted to the wooden block and folded over. a few small pieces of scrap cloroplast finished it up
I decided to use a prescription pill bottle to hold the power switch and batteries, and I would use a small tupeware container for the plasma vents, and
Id use two tape cores for the muzzle. Originally I was going to install a small fan in the vent to give it a nice power up sound. or as Sgt Schlock my say "that Ominous HUMMM!!!" but that was impractical. To show the plasma spark chamber I used the tops of 2 pringles cans.
I cut away the PVA foam to fit in the spark chamber. coated the inside with a layer of aluminum foil and threaded 8 leds (4 to each side) through the pva into the spark chamber. I then threaded a number of leds through the cloroplast so it would emerge in the plasma vent chamber. I painted the pill bottle and tupeware containers with 3 coats of black spray paint the cloroplast and pill bottle top was sprayed with 3 coats of gray paint. I then ran one more LED into the muzzle of the blaster. the vents and spark chamber light up with the switch in the battery pack, and a momentary switch
ls connected to the muzzle so that only lights up on the pull of the trigger.
Its not yet finished I need to do some detail work, and wrap the grip. I'm also thinking to tearing out the LEDs in the spark chambers and replacing it with cheap novelty plasma belt buckles
What do you folks think?