Forum adverts like this one are shown to any user who is not logged in. Join us by filling out a tiny 3 field form and you will get your own, free, dakka user account which gives a good range of benefits to you: No adverts like this in the forums anymore. Times and dates in your local timezone. Full tracking of what you have read so you can skip to your first unread post, easily see what has changed since you last logged in, and easily see what is new at a glance. Email notifications for threads you want to watch closely. Being a part of the oldest wargaming community on the net. If you are already a member then feel free to login now.

Hi , im abit confused about the front armor plate add on for the Witch Hunter Exorcist.

The plate itself is flat . But the front of the rhino its supposed to be attached to isnt flat.
It has a raised armor plate near the bottom.

What am i doing wrong o_o

Is it ment to completely replace that whole part? or go over it?

Could you post a photograph of the offending part please Luna?

Luna, the metal plate goes directly over the top of the plate at the bottom. If you look at the metal bit, it has a windscreen in the top-right corner; and 'hooks' onto where you would normally put the plastic cover on. Don't worry about it being raised up at the bottom as the piece should sit in place. You're not doing anything wrong, it's just a really annoying model to put together properly

I have 2 Exorcists, and both are slightly different. One fits quite snugly and just required a little greenstuffing to fill in gaps. The second one needed pinning in place and a lot of gs to keep in place.

Hope this helps; i'm off to play some bb now, but pm me if you're still stuck and i'll take some pictures for you when i get back

K here is the pic .

Red = that piece isnt supposed to be glued on because the exorcist flat armor plate goes on it.
However , the green area is not an option to be added , its 1 piece molded like that.
Which means when the exorcist plate goes on it , it'll be raised towards the bottom making the whole thing
slanted and impossible for me to glue

You could always cut/file the offending piece down so it looks right when you put the plate on.

I DID IT!!!!! after years of not knowing what to do , its finally in ONE PIECE!@

WOW

So how did you do it?

some pics might help. Would allow us to see what the issue was and how you solved it.
I don't play with the gunbunny nuns myself.

chromedog wrote:So how did you do it?

Pixpls kthxbai.

I cut the whole bottom part off (the whole armored / raised area is gone ), since its way easier than to sand or slice evenly.

Yay!
(the issue was in the diagram above . The exorcist armor plate cannot fit on the original rhino
due to the green part is raised and not flat.)

PICS damn you!!! I wanna see your toys!

aerethan wrote:PICS damn you!!! I wanna see your toys!

Ok here are some toys!

Its interchangeable between Rhino to Immolator to Exorcist , and even Whirl Wind!

Mega Immolator with Whirl Wind missile!

And something that you will NEVER want anyone touching! When i assemble the rest of the exorcist , they each will have one of the angels

Your table wins.

And its just not fun without Pikachu abuse , HEAVENLY DELTA ATTAAAAAAAACK~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

You must be careful with those spears...you never know where their ends might end up.

I built mine for a emperors children army and it is slightly modified the piano part is where the servitor sits and I gave the armor plates to a friend.